Help
I swap the C52 with a 4AGZE AE111 tranny and had problems aligning the mounts? if I put the rear mount first then the middle and the front would not aling, they were off for about 1/2 to 3/4 of an inch...
Page 1 of 1
Fitting AE111 4AGZE Tranny into 88' AE92 GTS
Rate Topic:
#1
- Newbie
-
- Group: Members
- Posts: 4
- Joined: 03-June 10
- Gender:Male
- Location:Orlando, Florida
Posted 03 August 2011 - 06:14 AM
#2
- Newbie
-
- Group: Members
- Posts: 4
- Joined: 03-June 10
- Gender:Male
- Location:Orlando, Florida
Posted 03 August 2011 - 01:36 PM
Using the stock NA 16v engine, I swap the C52 with a 4AGZE AE101 tranny and had problems aligning the mounts? if I put the rear mount first, the middle and the front mount would not aling with the holes, they were off for about 1/2 to 3/4 of an inch towards the front of the car...
This post has been edited by Carlos4age: 03 August 2011 - 01:51 PM
#3
- Member
-
- Group: Members
- Posts: 43
- Joined: 17-October 07
- Gender:Male
- Location:fiji
- Interests:fast cars and loud sound systems
Posted 22 August 2011 - 09:08 AM
#4
- Newbie
-
- Group: Members
- Posts: 4
- Joined: 03-June 10
- Gender:Male
- Location:Orlando, Florida
Posted 22 August 2011 - 12:22 PM
torcha8, on 22 August 2011 - 09:08 AM, said:
Thanks for the help, but I'm done with that set up, I'm swaping a complete engine + trans from an AE111 BZR 4AGE 20V Blacktop 6 speed, I hope this goes a lot better...
This post has been edited by Carlos4age: 22 August 2011 - 12:22 PM
#5
- Regular poster
-
- Group: Members
- Posts: 189
- Joined: 03-December 10
- Gender:Male
Posted 22 August 2011 - 09:14 PM
They don't bolt straight in... Front / rear do, but the side one doesn't.
You can easily modify the c52 mounts to make it fit, drill + grind a little of the selector bracket. Hope u got the shifter as they are different as well
You can easily modify the c52 mounts to make it fit, drill + grind a little of the selector bracket. Hope u got the shifter as they are different as well
Share this topic:
Page 1 of 1